| 1. | The analysis results show that the mother band and solidified layer are bonded through the transition layer formed by element diffusion
经分析得知母带与凝固层的界面结合是靠元素相互扩散形成过渡区实现的。 |
| 2. | A multiple transition layer ( ti and tin ) was deposited on stainless steel before depositing sic film , and result in significant improving adhesion of sic film to stainless steel
采用中间复合过渡层技术，可以提高sic膜与不锈钢基体的结合强度。测量了500时带sic膜316l不锈钢的氚渗透率。 |
| 3. | Therefore through a stress analysis to transition layers and main core , it is studied to improve stress conditions by canceling auxiliary core so as to make direct contact between main core and transition materials
因此通过对过渡层与心墙应力状态分析，研究取消副墙，主墙与过渡料直接接触，来改善应力条件。 |
| 4. | The physical process of quasi - isentropic compression might be considered as the successive overlap of a series of small shock loading waves generated by the transition layers in the flier - plate
波阻抗梯度飞片对靶板的压缩过程是一系列弱冲击加载波相继发生作用叠加的结果，靶板由此获得的尸一v线是一组通过不同初始状态点的hugoulot线的连线 |
| 5. | Pbo - b _ 2o _ 3 - sio _ 2 glass reacts with bismuth ruthenate and lead ruthenate is produced as transition layer . the transition layer can make the interface gradually change and the properties of resistors are improved at the same time . based on the study above , the way to get series of pastes was developed
铅硼硅玻璃粉体平均粒径对厚膜电阻的性能影响有一极值点,约为1 . 51 m ,在该点处膜层的方阻值最小,电阻温度系数绝对值最小,重烧变化率最接近零值。 |
| 6. | Meanwhile , the factors causing fissures in the pavement fall into three layers from down to up , namely , the bottom layer of the pavement slab - the formation and fissures & breakage of the transition layer between the pavement and base interface makes the chief reason for the formation of initial cracks and later fissures ; the middle layer - the pavement plate
同时，将路面开裂的影响因素由下而上分为三个不同的层面，即：路面板底层? ?路面与基层界面之间过渡层的形成及其开裂，是导致初始裂缝形成和影响后期开裂的根本原因；中间层? ?路面板体。 |
| 7. | And the transition layer ti between tio2 and tin can improve the transmittance of tio2 / tin . in triple layers the exterior tio2 can increase the transmittance of tio2 / tin / tio2 , so do the transition layer ti film between tio2 and tin . after treated at 300 c tio2 / tin / tio2 has no difference with non - heat - treated triple layers , and when treated at 400 c the transmittance of the films increase and the curve shift to the red
结果显示，在tio _ 2 tin多层膜中， tin溅射沉积时间较短时，薄膜在紫外?可见光范围内呈现出较高的透过率；随着tin薄膜溅射时间的增长，透过率武汉理工大学硕士学位论文逐渐降低;在tio :与tin之间镀制一层ti膜过渡层可以提高双层薄膜ti02ztin的可见光透过率。 |
| 8. | This work using negative bias to improve the nucleus density , and quartz glass was used as a kind of depositional substrate and diamond was deposited upon it in an mpcvd equipment . the diamond coating was characterized by xrd sem rama xps . the experimental results show that the mostly component of the film is diamond , and the results show that the sic is exist . it show that the diamond film not grow directly on the quartz glass , there exist the sic transition layer
在mpcvd制备得到了金刚石薄膜之后，分别用x衍射( xrd ) 、扫描电镜( sem ) 、拉曼谱( raman )和光电子能谱( xps )等测试手段对金刚石薄膜进行了表征，结果表明了生长出来的薄膜的主要成分是金刚石，同时发现了sic的存在，这表明了用mpcvd在石英玻璃上生长金刚石薄膜时，不是直接生长在sio _ 2上，而是有一个过渡层sic ，然后在过渡层上再生长一层金刚石薄膜。 |
| 9. | The physical process of generating quasi - isentropic compression on target via flier - plates with graded wave impedance might be considered as the successive overlap of a series of small shock loading waves generated by the transition layers in the flier - plate . as a result , the p - v curve of the target was a quasi - isentropic compression curve , which consisted of small hugoniot curves ( similar to isentropic curves ) from different original states , and was located between the hungoniot curve and isentropic curve but closer to the latter
波阻抗梯度飞片对靶板的压缩过程是一系列弱冲击加载波相继发生作用叠加的结果，靶板由此获得的p - v线是一组通过不同起始状态点的hugoniot线的连线，这条连线可以近似看作是由小段小段等熵线连接而成的准等熵线。 |
